- Pet stroller can be taken on the planeSOS Leak Sensor

Title Default Title
Qty:

Description

  • SOS Leak Sensor
  • Offers four re-usable sponge-tipped probes
  • Detects water leaking into an improperly sealed Watertight Enclosure
  • Lets you monitor all corners of a Watertight enclosure
  • Operating Voltage: 3.3 - 5 V
  • Maximum Current Draw: 20 mA

The SOS Leak Sensor detects water leaking into an improperly sealed Watertight Enclosure quickly and reliably before any major damage can occur!

Though a leak is unlikely, the SOS Leak Sensor will give you additional peace of mind that your electronics are safe.

Four re-usable sponge-tipped probes with an adhesive backing let you monitor all corners of a Watertight enclosure, from the penetrators to the front and rear flanges.

When a leak is detected, the signal is pulled high to VCC and bright red LED shines, making it easy to integrate with an Arduino, Raspberry Pi, Pixhawk, and many other 3.3 or 5 V devices. The ArduSub firmware supports the SOS Leak Sensor on the Pixhawk by default.

  • 1 x SOS Leak Sensor Probe Host Board
  • 2 x 6-inch Probe
  • 2 x 12-inch Probe
  • 4 x Replacement Probe Tip
  • 1 x 4-inch Three Pin Extension Cable
  • 1 x Double Sided Foam Tape
  • 8 x Zip Tie

PDF File

  • Operating Voltage: 3.3 - 5 V
  • Maximum Current Draw: 20 mA
  • Output Connector: 3 pin 0.1 inch header
  • Input Connector: 4 x 2 pin JST-GH